HOME

Order Online Here

 SOLID SPACER INSTALLATION INSTRUCTIONS:

 1. Measure the used Crush Sleeve that was originally in the housing. (if not available start with 3 shims)

 2. Add enough Shims to the spacer to achieve a total length that is slightly longer than the used Crush Sleeve.

 3. Install Spacer and torque the Pinion Nut to 125 foot pounds.  At this point pinion pre-load should be loose.

 4. Remove the Spacer and Shims. Reduce this Shim Pack in .002 thickness increments and install until the proper bearing pre-load is achieved.

                             .010 -1  .020 .020                   .036 .016,.020
                             .012 -2  .022 .010,.012           .038 .010,.012,.016
                             .016 -1  .024 .012,.012           .040 .012,.012,.016
                             .020 -1  .026 .010,.016           .042 .012,.010,.020
                                           .028 .012,.016           .044 .012,.012,.020
                                           .030 .010,.020           .046 .010,.016,.020
                                           .032 .012,.020           .048 .012,.016,.020
                                           .034 .010,.012,.012   .050 .010,.012,.012,.016